USE & SAFETY INSTRUCTIONS

GENERAL SPRAY INSTRUCTIONS FOR 1/2 OZ CANS:

1. Twist the red actuator lever to the right.

2. Aim at the attacker’s face and firmly depress the red actuator lever.

3. Spray in short bursts until the attacker is repelled or ceases to exhibit aggressive behavior (typically 1-2 bursts will subdue most attackers).

4. Exit the area immediately.

5. Contact the police.

GENERAL SPRAY INSTRUCTIONS FOR 3 & 4 OZ CANS:

1. Grab the can with a fist-like position and put your thumb under the safety flip-top cover and on the trigger.

2. Aim at the attacker’s face and firmly depress the trigger with your thumb.

3. Spray in long bursts until the attacker is repelled or ceases to exhibit aggressive behavior (typically 1-2 bursts will subdue most attackers).

4. Exit the area immediately.

5. Contact the police.

CAUTION:

• Contents under extreme pressure. Do not expose to heat or store at temperatures exceeding 44° C (120° F). For use as a self-defense spray ONLY! Avoid accidental contact with skin or clothing.
• Pepper Spray will incapacitate a person for up to 45 minutes with no after-effects. Unlike other aerosol defense weapons, pepper spray is effective on people who are pain resistant, under the influence of alcohol, narcotics, emotionally enraged or psychotic. Additionally, Pepper Spray will repel attacking animals.
• Failure to follow these instructions may result in first or second degree burns, severe skin irritation, or other skin injury.

EFFECTS:

Pepper Spray will cause the attacker’s eyes to close, produce uncontrollable coughing, disorientation, panic, and a loss of muscular strength and control.

FIRST AID:

Remove contact lenses and contaminated clothing immediately. Flush infected area with large quantities of cool water or a diluted baking soda solution and expose the area to fresh air as soon as possible. Do not apply salves, creams, oils, or lotions as they can trap the irritant agent against the skin and result in blisters or burns. Consult a physician if irritation persists. Contaminated clothing should be washed or dry-cleaned, as appropriate, before re-use to prevent skin injury.

IMPORTANT NOTICE:

Common sense must be used at all times in connection with the use of any nonlethal aerosol self-defense product. It is not recommended to be against any person armed with a gun, knife, or any other lethal weapon unless there are no other means of defense or escape. While this is an effective personal defense product, it is not a substitute for individual precautions or diligence. Escape without actually physically engaging the assailant is the best alternative, and the use of your unit should be as a last resort.

LEGAL RESTRICTIONS:

If you have any questions about the legality of purchase, possession, or use of this product in your locality, you should check with local law enforcement agencies. Carrying or transporting this product on any passenger aircraft is unlawful. This product is designed for personal self-defensive purposes only. This product should only be used by persons 18 and up.

USING PERSONAL SAVERS PRODUCTS:

To be effective, your Personal Savers product MUST be immediately accessible to you. During a moment of stress or surprise, you may not have the time to search for your product. Therefore you should always be aware of exactly where your product is and be able to reach it without delay. When you believe that you’re in, or maybe in a situation that could give rise to the use of your Pepper Spray, take it out of its holder and put in your hand (gripping it firmly so it cannot be taken from you). Unlock the red actuator lever by twisting to the right and, if necessary, press down firmly on the actuator, using short bursts aimed directly at the face of the attacker(s). The product is most effective when you engulf the attacker’s eyes, nose, and mouth. Continue to use short bursts until the attacker is repelled then IMMEDIATELY escape to safety. Notify the police as soon as possible. You should shield your face and eyes if firing into the wind.

WRIST SAVER INSTALLING DIRECTIONS:

1. Install the Pepper Spray can through the Wrist Saver loop (the part with the logo) with the red actuator part of the can facing away from your body.

2. Install the LED light into the LED light holder next to the ID card window.

3. Make sure the LED light has the on/off switch side inserting up, so it’s easier to turn your LED light on and off. The on/off switch is the little switch located towards the light.

4. Wear the Wrist Saver on your right hand with the Pepper Spray can on top of your wrist. This position will let oncoming cars see you better since the Wrist Saver will be on the outside part of your body.

5. Make sure the red actuator lever is in the lock position before wearing it.

WRIST SAVER USE DIRECTIONS:

1. When defending yourself from an attacker, pull the Pepper Spray can out of the Wrist Saver.

2. See Pepper Spray Can Use instructions for a 1/2 oz can.

WRIST SAVER ID CARD DIRECTIONS:

1. Pull back the neoprene boarder around the PVC clear window to see the opening towards the end of the band.

2. Pull out the ID Card.

3. Write your emergency information on the back of the card.

4. Insert the ID Card back into the holder.

GRIP IT INSTALLING DIRECTIONS:

1. Slide the pepper spray can through the two rubber strap holes.

2. Position the can between the two rubber holes so that there is approximately one inch from the top and bottom of the can to each strap. The can now will have a perfect center position within the strap.

3. Slide your middle finger through space between the can and the wide part of the strap.

4. With can securely fasten to your hand, grab the can and form a fist.

5. Adjust the can so that the spray nozzle is pointed anyway from you, and you can quickly gain access to the trigger with your thumb.

GRIP IT USE DIRECTIONS:

1. See Pepper Spray Can Use instructions for a 3 oz can.

CYCLE SAVER INSTALLING DIRECTIONS:

1. Clamp the Cycle Saver mounting bracket onto the top of your handlebars, so it sits horizontal to the ground. Use the rubber spacer to compensate for certain thicknesses of different handlebars.

2. Once the mounting bracket is clamped onto the handlebars, use the screw provided to tighten down the mounting bracket from the bottom.

3. Snap the Pepper Spray can into the bracket.

4. Make sure the red actuator lever is in the lock position.

CYCLE SAVER USE DIRECTIONS:

1. When defending yourself from an attacker, stop and get off bike (DO NOT SPRAY WHILE RIDING).

2. Put your bike between yourself and the attacker.

3. Pull the Pepper Spray can out of the mounting bracket.

4. See Pepper Spray Can Use instructions for a 1/2 oz can.

BARRICADE BRACKET INSTALLING DIRECTIONS:

There are multiple ways to mount the Barricade to your bike to work with your bike’s geometry.

Water Bottle Mounting

1. Use the water bottle mounting screws provided to secure the Barricade bracket to your water bottle mounting area on your bike. If you already have a water bottle cage on your bike, the Barricade is designed to fit under the water bottle cage.

2. Place the Barricade mount with the rubber side down and align the bracket mounting holes with the holes on your water bottle mounting area on your bike.

3. Screw the Barricade mount to your bike.

4. If you have a water bottle cage already on your bike. Take off your waterbottle cage from your bike and align the Barricade bracket with the holes on your water bottle cage.

5. Use the provided screws that came with the Barricade to screw both your water bottle cage and Barricade to your water bottle mounts on your bike. Do not try to use your original screws, since they will not be long enough.

Strap Mounting

1. Place the Barricade bracket with the rubber side down in a position on your bike that fits your geometry. There are endless ways to mount the bracket from your seat post, down tubes and top tubes.

2. Once you find the exact place you would like to mount the bracket, use one of the two silicone velcro straps provided to fasten the bracket to your bike. There are two different sized straps to accommodate different diameter mounting spots.

3. Wrap the velcro strap with the silicone side down towards the bracket, so the silicone can grip your frame or seat post when you tighten the strap. Feed the end of the velcro through the plastic loop and tighten the strap.

4. After tightening the strap, the bracket should be securely fastened to your bike. There shouldn’t be any wiggling of the bracket once attached to your desired mounting position. If there is any wiggle in the mount, try mounting it in a different location on your bike.

PEPPER SPRAY CAN INSTALL:

1. Snap the pepper spray can evenly into the two U shaped can mounts so that the spray nozzle is facing out.

2. Make sure the can is perfectly center between the two mounts once it’s snapped into the bracket.

3. Fasten the two rub straps over the outside of the can. There’s a lip on each side of the U shaped mounts, where the rubber strap will securely fasten to.

BARRICADE USE INSTRUCTIONS:

1. Come to a complete stop on your bike.

2. Unclip the rubber straps that are around the can by pulling the thick tab part and unclipping the rubber straps from the mounting lip.

3. Pull the pepper spray can out of the mounts.

4. See Pepper Spray Can Use instructions for a 4 oz can.

PERSONAL SAVER INSTALLING DIRECTIONS:

1. Install the Pepper Spray can inside the holder.

2. Make sure to position the Pepper Spray can so the shooting nozzle is always pointing through the U shape opening of the holder, so you have a clean unobstructed shot.

3. Install the LED light in the front pouch of the Personal Saver holder.

4. Make sure the LED light has the on/off switch face out.

5. You can either push the center to turn on the LED light or use the small on/off switch to keep it on constantly.

6. Attach the Personal holder to your key chain, backpack, belt, car visor, and purse or carry it by itself.

7. Make sure the red actuator lever is in the lock position on the Personal Saver.

PERSONAL SAVER USE DIRECTIONS:

1. When defending yourself from an attacker, grab your Personal Saver holder. Twist the red actuator lever to the right on the Pepper Spray can.

2. See Pepper Spray Can Use instructions for a 1/2 oz can.

TRAIL SAVER INSTALLING DIRECTIONS:

1. Install the Pepper Spray can inside the holder.

2. Make sure to position the Pepper Spray can so the shooting nozzle is always pointing through the U shape opening of the holder, so you have a clean unobstructed shot.

3. Attach the Trail Saver holder to your backpack or belt by using green clip hook or belt clip.

4. Attach the green clip and LED light to the keyring. Insert the whistle in the front pouch of the holder that has the Trail Saver logo on it.

5. To turn on the LED light, you can either push the center of the LED light or use the small on/off switch to keep it on constantly.

TRAIL SAVER USE DIRECTIONS:

1. When defending yourself from an attacker, grab your Trail Saver holder a solid grip. Simple flip up the safety top and put your thumb on the trigger and aim at the attacker.

2. See Pepper Spray Can Use instructions for a 4 oz can.

OUTBACK SAVER INSTALLING INSTRUCTIONS:

1. You can either clip the Outback Saver using the blue clip to any part of your backpack or store it away inside your pack.

OUTBACK SAVER USE INSTRUCTIONS:

1. Unclip or retrieve the Outback Saver from your backpack.

2. Grab the pistol grip firmly in your hand, aiming it at your attacker.

3. Push up the orange safety tab up with your thumb to unlock the top trigger.

4. Press down on the top trigger to fire the pepper spray can at your attacker.

5. Fire the pepper spray can as often or as long as needed until the attacker is repelled or ceases to exhibit aggressive behavior.

6. Exit the area immediately.

7. Contact the police.

BABY SAVER INSTALLING DIRECTIONS:

1. Install the Pepper Spray can through the Baby Saver loop (the part with the logo) with the red actuator part of the can facing away from your body.

2. Wrap the Baby Saver band around the most accessible part of your wheeled jogger’s bars for easy access.

3. Velcro the two ends of the Baby Saver together.

4. Make sure the red actuator lever is in the lock position before putting on your wheeled jogger.

BABY SAVER USE DIRECTIONS:

1. When defending yourself from an attacker, pull the Pepper Spray can out of the Baby Saver.

2.  See Pepper Spray Can Use instructions for a 1/2 oz can.